The Challenges to Swim Spa Covers

Swim Spas represent special challenges when it comes to covering them.
We can all agree that the swim spa has to be covered when not in use for all the same factors a hot tub needs a cover. The challenge is that because of the length of the swim spa and the height of the sides, eliminating and replacing the cover can be a lot harder.
Getting a brand-new swim spa is an exciting occasion in life. You’re anticipating the workout you’ll obtain from using it. Perhaps you’re a little relieved to have finally selected from the different designs you looked at. At any rate, you probably weren’t believing much about the cover you would use.
Generally, the cover that gets back with your new purchase will be a four area rigid foam filled cover that will split in the center and go off both ends.
No big deal.
Up until it begins to get heavy.
Which it always does.
Every stiff foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a style flaw. Built in obsolescence due to the fact that as quickly as it is put in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper will not make any difference. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The molecules of steam are extremely small as they rise from the water surface. They make their method into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes caught in the cover.
It occurs gradually and on a Swim Spa Cover which is made of specific sections, at varying speeds. So ultimately you’ll observe one or two of the areas are truly getting heavy. The bar lifters on completions of the swim spa aren’t much aid since you still need to lift that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com developed a different style for their Swim Spa Covers
Instead of using a number of foam panels to build Swim Spa Covers that will ultimately end up in some landfill, they developed one that uses air chambers that do not suck up moisture.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate better, will not blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine material, these covers will not fade, or fall apart at the joints either. So if you own a swim spa, and you intend to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not ready to purchase today, bookmark this site so you can discover it again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *