Getting The Best Swim Spa Cover

Swim Spas represent distinct difficulties when it comes to covering them.
We can all agree that the swim spa has to be covered when not in use for all the same reasons a hot tub needs a cover. The challenge is that because of the length of the swim spa and the height of the sides, removing and replacing the cover can be a lot more difficult.
Getting a brand-new swim spa is an exciting event in life. You’re eagerly anticipating the exercise you’ll get from using it. Perhaps you’re a little relieved to have actually lastly made a selection from the different designs you took a look at. At any rate, you most likely weren’t thinking much about the cover you would use.
Normally, the cover that gets back with your new purchase will be a 4 section stiff foam filled cover that will divide in the center and go off both ends.
No big deal.
Until it starts to get heavy.
Which it constantly does.
Every rigid foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design flaw. Built in obsolescence because as soon as it is placed in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper won’t make any distinction. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The molecules of steam are really little as they rise from the water surface. They make their method into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being caught in the cover.
It takes place gradually and on a Swim Spa Cover which is made from private sections, at differing speeds. So ultimately you’ll notice a couple of of the sections are actually getting heavy. The bar lifters on completions of the swim spa aren’t much help because you still have to lift that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com created a different design for their Swim Spa Covers
Instead of using several foam panels to construct Swim Spa Covers that will ultimately end up in some land fill, they developed one that uses air chambers that do not suck up wetness.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, will not blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine material, these covers will not fade, or break down at the joints either. So if you own a swim spa, and you plan to keep using it daily, SpaCap.com has the cover for it.
If you’re not prepared to order today, bookmark this website so you can discover it once again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *