Getting The Best Swim Spa Cover

Swim Spas represent distinct difficulties when it concerns covering them.
We can all agree that the swim spa has to be covered when not in use for all the same reasons a hot tub requires a cover. The difficulty is that because of the length of the swim spa and the height of the sides, getting rid of and replacing the cover can be a lot harder.
Getting a brand-new swim spa is an interesting occasion in life. You’re anticipating the workout you’ll get from using it. Perhaps you’re a little relieved to have actually lastly made a selection from the various models you took a look at. At any rate, you most likely weren’t thinking much about the cover you would use.
Usually, the cover that comes home with your brand-new purchase will be a 4 section stiff foam filled cover that will divide in the center and go off both ends.
No big deal.
Till it starts to get heavy.
Which it always does.
Every rigid foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design defect. Integrated in obsolescence due to the fact that as quickly as it is positioned in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper will not make any difference. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The molecules of steam are really small as they increase from the water surface area. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.
It occurs gradually and on a Swim Spa Cover which is made of individual sections, at varying speeds. So eventually you’ll observe one or two of the areas are actually getting heavy. The bar lifters on completions of the swim spa aren’t much help due to the fact that you still have to raise that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com came up with a different design for their Swim Spa Covers
Instead of using a number of foam panels to build Swim Spa Covers that will ultimately end up in some garbage dump, they developed one that utilizes air chambers that don’t suck up moisture.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate better, will not blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine material, these covers will not fade, or break down at the joints either. So if you own a swim spa, and you plan to keep using it daily, SpaCap.com has the cover for it.
If you’re not ready to order today, bookmark this website so you can discover it again when you’re prepared!

Leave a Reply

Your email address will not be published. Required fields are marked *